Gold Star Resincast
RESINCAST was developed by GSP – tried and tested by jewellery manufacturers worldwide. It is designed primarily for investing and burnout of CAD/CAM rapid prototype resin and resin/wax patterns.
RESINCAST is an investment powder for CAD/CAM resin casting, offering the following benefits:
Highest Quality raw materials sourced and graded for Resin/CAD casting
Formulated with a greater green strength enabling it to withstand the high Resin/CAD expansion
Can be used with any Resin/CAD manufacturer
Clean cut surface finish, sharp edges, without inclusions
Easy removal after casting, like your regular Gold Star investment powders
Gold Star Resincast has
Resincast can also be used to produce injection wax castings and will easily cast all gold alloys.
Technical Specification
Do not burnout or steam de-wax flasks until a minimum of 90 minutes after investing. During this 90 minute period flasks should not be touched, this includes stripping bases and removing vacuum tape. Do not load flasks into a hot furnace. Always follow the recommended burnout cycle and never place flasks closer than 15mm to elements. Always ensure you do not over or under load your furnace, as this will affect the burnout cycle.
Do not remove flasks from furnace to cast until they have been held at casting temperature for a minimum of 1 hour.
If held for less t
| WATER TO POWDER RATIO | |
| Conventional Mixing | 40:100 |
| Vacuum Mixing | 38:100 |
| Conventional Mixing | min. |
| Add Powder To Water | - |
| Machine Mix | 4 |
| Vacuum Bowl | 1 |
| Pour flasks | 1 |
| Vacuum flasks | 2 |
| Total time taken | 8 |
| Vacuum Mixing | min. |
| Add Powder To Water | - |
| Mix Under Vacuum | 5 |
| Pour Flasks | 2 |
| Hold Under Vacuum | 1 |
| Total time taken | 8 |
